CS-811 solar photovoltaic special sealant

Mainly used for bonding and insulation of small household appliances such as induction cookers and rice cookers; The waterproof and moisture-proof of outdoor products, the sealing of solar cell module frames, the sealing of solar lamps, and the junction box of solar cell modules play a role in adhesive sealing.

Clean the construction surface thoroughly, cut off the top of the nozzle according to the amount used, seal it on the packaging mouth, apply it to the construction surface, and place it in the air. The surface of this product will lose its stickiness (surface dryness) after 10-30 minutes at room temperature, and it will completely cure within 8-24 hours. Heating this product cannot significantly change its curing speed.

Unused adhesive should be stored in a sealed container. The storage period is 6 months (25 ℃).

This product is non hazardous, but should not be ingested or seen.

Transportation: There are no regulations for domestic (CN-GB) or international (IMO, IATA, UN) transportation. Belonging to non dangerous goods.

Before curing: ① Appearance: Black paste ② Product type: Mixed ③ Viscosity surface drying time (min, 25 ℃): 5-20 ④ Relative specific gravity: 1.50 ± 0.05

Operational performance: ① Surface skinning time (min, 25 ℃): 10-30 ② Curing time (min, 25 ℃): 8-12 hours (3-5mm) ③ Curing time (min, 80 ℃)

After curing: ① Hardness (shore A): 40-50 ② Tensile strength (MPa): ≥ 1.90 ③ Dielectric strength (kV/mm): ≥ 15 ④ Dielectric constant (100MHz): ≤ 3.5

⑤ Volume resistivity (Ω· cm): ≥ 1.0 × 1014 ⑥ Elongation at break (%): 400-700 ⑦ Tangent value of dielectric loss (1MHz): ≤ 2.0 × 10-3

⑧ Temperature range for use (℃): -50 ℃ -180 ℃ ⑨ Flame retardant grade: 94V0

CS-811 electromagnetic stove and solar photovoltaic special sealant have the following characteristics:

This product is a single component organic silicon compound, in the form of a black paste.

This product has good high and low temperature resistance, earthquake resistance, corona resistance, anti leakage insulation, corrosion resistance, weather resistance and other characteristics. After solidification, the colloid can be used over a wide temperature range.

During the curing process, it does not shrink and has good waterproof, moisture-proof, and insulating properties.

Compliant with the EU ROHS directive requirements